MP-Pistol Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
anyone use the accu wedge ? I got one but it so tight i would have to trim it any thoughts?
 

·
Site Staff
Joined
·
9,615 Posts
The Accu Wedge is the solution for a non existent problem, due to the design the fit of the upper to the lower doesn't really affect accuracy in an AR, a loose one will shoot every bit as good as a tight one, any observed effects are strictly psychological.
 

·
Registered
Joined
·
16 Posts
Discussion Starter #4
Yeah thats what i was thinking my M&P15 std. is a tight fit with out question......well that was a waste of 4.00 bucks :roll: ......Thanks Guys!
 

·
Registered
Joined
·
1,522 Posts
I don't have any ARs that the accu-wedge will fit into.



If your cheek weld is so spot on perfect and repeatable that the upper/lower slop is causing inaccuracies, then maybe you need something like the accu-wedge. However, I'd suggest a JP tension pin to replace the rear pin as it is not elastic like the accu-wedge.
 

·
Site Staff
Joined
·
9,615 Posts
Yes, it's adjustable, so it's easy to get it just right, but you seldom see one loose enough to make any difference, maybe the Army's got some old shot out, worn out M16's that could use it.
 
1 - 6 of 6 Posts
Top