MP-Pistol Forum banner
1 - 1 of 10 Posts

· Registered
1,160 Posts
I just had both the front and rear out today for a full cleaning and some polishing. The front rail are attached to a small block that holds the take down lever and the trigger housing/slide stop in place (these are different pieces though). The rear is a part of the sear housing. Both can definitely be replaced if the front assembly is available. (probably free through Smith)
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.