MP-Pistol Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,277 Posts
Discussion Starter · #1 ·
Have occasional fails to extract. Could this be due to dirt "behind" the extractor? I.E. between it and the body of the slide(forward of the pin).

If so how to clean.
 

·
Registered
Joined
·
168 Posts
Make sure you're getting the extractor hook clean too - the part that interfaces with the cartridge rim. A pipe cleaner works well.



You should be able to move the extractor by hand - see if it binds or feels gritty.
 

·
Registered
Joined
·
855 Posts
I flood the extractor with clp or similar, then move the extractor in its normal arc. Then I soak all the crud out with a papertowel and then blow it out with canned air.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top