MP-Pistol Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
sorry if this is a repost but has anyone tried the trigger job themselves, was it easy? what files did you use or would it be worth it to just buy a new sear from brownells? by the way i have a Mass model 10lb trigger no mag disconnect no internal lock
 

·
Registered
Joined
·
1,507 Posts
I am the wrong guy to ask how hard the trigger job is, but if you have the mass trigger you would be best served by replacing the sear block and trigger assembly with the normal M&P parts rather than the Mass compliant ones you currently have. then you can do the trigger job. Just following the directions on a mass gun will not yield very good results.
 
1 - 3 of 3 Posts
Top