MP-Pistol Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
I'm thinking about buying this and using my Dremel 4000 to mill off the two rear nubs and then slightly lower the two front nubs, so I can mount an RMSc optic.
Has anyone any experience with this? Do you think the clearance can be tight enough to mill the nubs without scraping up the rest of the slide surface?


Gesture Camera accessory Automotive tire Cameras & optics Bumper
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #2 ·
I'm trying for a more professional approach vs what this guy did on his hellcat.
If I had the budget (and room for it), I'd step up a bit $-wise and get a routing table for my router.
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #6 ·
Thanks for the info!

Btw, I just checked the slide with my calipers.
The front to rear of the optics cutout has a ~.30mm difference in height. So, it's slightly sloped.
 
1 - 3 of 3 Posts
Top