MP-Pistol Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
I posted this in the Smith Work forum, not sure if it will get answered there. So, I cleaned up the full size 9mm, and reassembled the recoil spring and guide rod onto the barrel and slide. When I replaced the slide onto the frame, it came back like normal, but the barrel and guide rod still protrude @ 1/2 " past the end of the barrel, and the slide won't come forward. It seems as if the barrel is hung up, can't see anything though. Any Ideas ??
 

·
Registered
Joined
·
14 Posts
Discussion Starter #2
Issue has been resolved. The tip of the guide rod must not have been seated in the recess completely, and it came out, preventing the slide from moving any further. I removed the take down roll pin, and the trigger assy. rollpin, and lifted the slide off, and fixed the problem. Put back together, and good for 100 rounds no problems.
 
1 - 3 of 3 Posts
Top