MP-Pistol Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter #1
Can anyone recommend a low cost holster for my 9mm full size? This will be for our steel plates shoots. I use a Blackhawk CQC holster for my 1911s but an even lower cost holster would be wonderful. I'll look into higher quality holsters for carry at a latter date.



Thanks, rjs
 

·
Site Staff
Joined
·
9,617 Posts
I've got this one from Uncle Mikes, it works fine for me, and it fits my rather small budget! The page says it's for a Glock, but it fits my MP40 just fine. You can probably find one of these in your local area and not have to pay Midways shipping charges.



http://www.midwayusa.com/eproductpage.exe/...&t=11082005
 

·
Registered
Joined
·
64 Posts
Discussion Starter #3
Thanks, John. I'll bet good, ol' Uncle Mike will get the job done. For the benefit of others, Uncle Mikes' numbers for the M&P from their website is 5317-1 rt hand belt slide and 5417-1 lft hand paddle. They make holsters for lefties, too.



rjs
 

·
Site Staff
Joined
·
9,617 Posts
All I had to do was adjust the tension screws, it looked like the holster was made for it. Back when I got the holster Uncle Mikes didn't have any listings for the MP pistols at all.
 

·
Registered
Joined
·
5,062 Posts
rjs said:
[quote name='choochboost']Tried one...didn't like the fit.


The gun in the holster or the holster on you?



rjs[/quote]

The gun in the holster. YMMV.
 

·
Registered
Joined
·
259 Posts
I too am using an Uncle Mikes and am very happy with it. My mp fits in it just fine. not a bad inexpensive holster.
 

·
Registered
Joined
·
157 Posts
Why not just get the Blade tech revolution ?
 

·
Registered
Joined
·
103 Posts
Life is too short to use cheap holsters. Use good quality-the Blade-Tech revolution is the absolute MINIMUM. I personally prefer leather from Matt Del Fatti, but the holster is not an area to be skimpy.



Joe
 

·
Registered
Joined
·
64 Posts
Discussion Starter #11
Thanks for the comments on holsters so far. The Revolution looks to be a pretty good holster (thanks for the tip) and I like my Blackhawk for my 1911s so might consider one for my M&P.



I will be looking into a higher quality, IWB holster for CCW when I get time. Everyone at our steel plate matches use OWB holsters.



Thanks, fellas.



rjs
 
1 - 11 of 11 Posts
Top