MP-Pistol Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I tried out an M&P 40 at a local indoor range yesterday. It was a range rental gun so it gets a lot of use, but I don't know the round count. The magazine kept releasing while shooting causing a failure to feed malfunction. At first, I though I might have my thumb on the release, but I shot it more and I did not have any part of my hands on the mag button when these malfunctions were happening.



Has anyone else encountered this issue? I'm speculating that if the mag catch is plastic, the steel magazines are wearing the locking surfaces of the plastic mag catch.
 

·
Registered
Joined
·
75 Posts
search some on the forum and you will find this discussed ad nauseum. Probably it is one of the original .40s
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Oops, I should have searched first before asking the question. My apologies. And yes it was a very early model .40 M&P
 
1 - 3 of 3 Posts
Top