MP-Pistol Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello,



I know there has been some discussion here regarding the mag release. S&W sent me a new one which I installed. This new one does not work any better than the original. If you press in on the mag release approximately 1/16 of an inch the mag will fall out. This would not be that big of a deal if you had to apply alot of pressure, but thats not the case, very little pressure is needed to release it. Have you also noticed this with the new mag release? Thank you!



techguy
 

·
Registered
Joined
·
115 Posts
I haven't gotten mine back from S&W yet. I will post the results when I do. I do know there is a number on the button. Mine was a 1. Make sure they didn't send you the same one you already had.
 

·
Site Founder
Joined
·
2,889 Posts
Please keep all mag release posts in the sticky above.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top