MP-Pistol Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Let me start off my saying this is one of the nicest firearm forums I have ever been too. Thx to the mods and webmaster ....



I'm just about to remove the finish on my wifes M&P9. I have removed the sights, not to bad compared to my XD's, and I no longer have any punches or drill bits left so the extractor will stay on (broke 3).



I want to remove the cap at the end that holds the striker and its related components so it does not get damaged but I don't see how to do it. Can someone please enlighten me?



Thx in advance ...
 

·
Registered
Joined
·
83 Posts
Here ya go:

http://www.youtube.com/watch?v=3BKwYNwox7Q

Right around 1min 12sec. Ignore the fact that it's a Glock - MP's come apart the same way in that matter.



You will have to push the firing pin block plunger a bit to get the striker assy in and out. Don't force it, just jiggle it a bit and it'll come apart.



Showing is better than telling as they say
 
1 - 2 of 2 Posts
Top