MP-Pistol Forum banner

mag jingle

5839 Views 21 Replies 11 Participants Last post by  KI4LIV
I'm getting tired of it... In both my mags on the 12th round it starts to jingle... on both mags that I have. Different rounds don't help. Practicing clearing drills today, and my mag in the pistol, and in the pouch are jingling away, dead giveaway to my posiition.



anyone else have this problem? btw its a 40.. hi-cap
1 - 20 of 22 Posts
Read your thread and tried both my mags. On the 12th round both mags jigle. Tried all the rounds and it only does it on the 12th. Thats weird. Took the mag apart and it looks like it could use a stronger factory spring. Im going to try and see if I have any other springs that might work just to try it out.
One of my fully loaded mags sound like there is a round loose. When I push the mag home I get a jigle. I haven't tried the other one yet. Doesn't seem to affect performance but it is a little aggrevating. I'm going to rack through the mag to see when it stops. Update later.....
i have 5 factory mags for the m&p and they all jingle when the mag is out of the pistol and loaded to 15 shots

but they all stop jingling
when i put them in the pistol

2 mags loaded with 180 grain federal hydrashoks and the other 3 loaded with 180 grain cci blazer
See less See more
I had mine loaded with 150 gr hydras, and also tried it with my reloads.
i have 2 boxes of 150 hydrashoks but i have not had a chance to shoot them yet

also 4 boxes of hornady 155 grain TAP but i have only put 1 clip through the pistol
So far I put about 400 150's through it, and not a burp.. I needed to trust this ammo before I'd ever carry it daily..
which load works best in your opinion factory and handloads
I like my handloads.. I tuned them to fit my dads USP and my M&P.



The hydras work well.. I don't like any of the factory range ammo through the chrono they are to spread out.
I had the rattle too...I just did what I do with all my mags that do that...slap the base against my hand and that "settles" the cartridges in the mag...no more rattle.
Being in the Marine mentality, I did the same thing, but they "resettle" and start jingling again.
I racked through the mag and on the 12th round, the jigle goes away. :?
Jester said:
I'm getting tired of it... In both my mags on the 12th round it starts to jingle... on both mags that I have. Different rounds don't help. Practicing clearing drills today, and my mag in the pistol, and in the pouch are jingling away, dead giveaway to my posiition.



anyone else have this problem? btw its a 40.. hi-cap


Hey jester when did you get your gun ? The reason I asked is because S&W changed the mag design a little bit from the original. We still have'nt gotten them but I'm told the finish is different (parkerized finish I think ) and some internal changes were made.However my rep either would'nt say or didnt know what they were.



If you have the original mags with the shiny finish you may want to call S&W and see if they'll exchange them for you.



good luck
Thanks, and yes mine are the shiny ones, and mine was the first one the dealer had in stock.
When I was at the range this weekend.. I noticed mine rattled also.. But I did the mag tap in my hand.. No rattle..




Ben
See less See more
I just got my pistol back from S&W today, it came with a magazine I didn't send out with it. It was still shiny. Other than being greasier than the other mags I have aquired, it looks the same. Shiny blued finish.
Has anyone seen the redesigned mags. I asked S&W if they did anything to change the mags and they told me no. Hopefully they did and the person I talked too just didnt know at the time.
I talked to a guy who knew his stuff last night, and he said no also. ](*,)
I got a new mag, and loaded it... No jingle, so I'm sending my 2 bad ones in.
some mags just do it.



post a pic of the follower from side view.



sigma mags will rattle. so will kel-tec p11
1 - 20 of 22 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top