MP-Pistol Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
208 Posts
Discussion Starter #1
Why can't I get my frame tool to turn and come out? I tried very hard to get it to move, but I feel like I am gonna break it. What am I doing wrong? Is there some trick to this? Thanks!
 

·
Registered
Joined
·
1,771 Posts
It's extremely difficult to say the least. Follow the link that Yukon posted and don't get discouraged...we've all been there.
 

·
Registered
Joined
·
2,535 Posts
RepeatDefender said:
Why can't I get my frame tool to turn and come out? I tried very hard to get it to move, but I feel like I am gonna break it. What am I doing wrong? Is there some trick to this? Thanks!


There was another thread on this, I had a problem myself. Dan Burwell said to use a thin cloth/towell and some channel locks and loosen it up then just pull it out, start with a 1/4 turn at a time. Also you can place it on a flat surface, and put pressure, but not too much and rotate it counter clockwise, once you get it loosened up it comes right out, your fingers will be numb for a bit, but it works......lol I would try the channel locks first, this does work easily!!!



Good luck
 
1 - 5 of 5 Posts
Top