MP-Pistol Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
111 Posts
Discussion Starter #1
Finished doing trigger job on my m&p today but i have a little problem.

if i very slowly pull the trigger back the sear doesnt release the striker until its touching the over travel stop. Guess i got a little carried away :oops:

went to the range put 50 rounds through it worked fine but it felt a tad sluggish on the break

went home and installed a wolf xp striker spring to see if that would help seemed to make it worse

going to install the factory striker spring soon as i post this.
 

·
Registered
Joined
·
1,507 Posts
If you didn't take material off the top of the sear yet you can and this will get you your over-travel back. Just don't reduce your sear/striker engagement to less then 0.030in.
 

·
Registered
Joined
·
111 Posts
Discussion Starter #4
Sorry for taking so long t respond back been busy.

Thanks for the advice Dan but i did take just a hair to much off the sear .

Ill have to order sear block assembly bronells guess ill order the newer version of the striker also.

Thanks
 
1 - 4 of 4 Posts
Top