MP-Pistol Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter #1
What pin punch do you guys use for the M&P? I'm wondering if I can go to the local hardware store and pick up a punch?
 

·
Registered
Joined
·
1,507 Posts
The take down tool works very well. I still think it is pretty cool that you can completly disassemble the gun without tools.



I use a drill rod that I modified to work on roll pins.
 

·
Registered
Joined
·
367 Posts
I went and bought a punch for the pins because I didn't think the plastic end on the take down tool would handle a beating from a hammer. My rear pin was tight enough to peel some metal back on the pin on the way out. Is the take down tool strong enough to smack it with a hammer a few times? Seems like I'd be hard to hit the flat too. I can see myself hitting the raised edge and busting it all to pieces.
 

·
Registered
Joined
·
367 Posts
Anyone know if I can hit the takedown tool with a hammer? I'd reather use it over the pin punch I bought (which is a little small). The one I bought mushroomed the end of the pin slightly. I'm also going to smooth the pin next time it comes out so maybe it won't be so tight.
 
1 - 7 of 7 Posts
Top