MP-Pistol Forum banner
1 - 2 of 2 Posts

12 Posts
Discussion Starter · #1 ·
The slide on my MP9 Rev. N is sticking when I attempt to put it back on the frame after disassembly. It will get almost all the way on, but the rear of the slide will not go onto the rear frame rails without a considerable amount of force. It is sticking on something, but I don't know what. I checked to see that everything is properly aligned (barrel, spring) and it's still happening. The takedown lever wants to spring right back into it's normal position when I'm attempting to reassemble the pistol as well, not sure if that's normal or not. Any suggestions?


Appropriate that I post the question and promptly figure out the solution. The dang internal lock was on and was causing some kind of hangup with the slide. I turned it off and the problem disappeared. Don't know if it's coincidence or if that was the actual problem; I'm just happy the problem went away
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.