MP-Pistol Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
246 Posts
Discussion Starter #1
Hi Guys,

I was digging around on the S&W site and ran across something that was causing me some concern. The slide assembly part numbers are different on the .357sig v/s the .40s&w. I got all worried that they may have made the outside diameter different on the barrels... Then it dawned on me. The caliber marking on the slide is different... DUH! Oh well, I will quit worring about this issue and try to be patient and wait till the barrels are available. Even if they do make the outside diameter of the barrels different, some aftermarket outfit will eventually make .357 barrels that will fit the fullsize .40. Barsto barrels comes to mind.



This is what happens when you are home sick and spending too much time in front of the computer. Time to go kick back and watch a movie.
 

·
Registered
Joined
·
5,726 Posts
I am looking forward to both the compact and full size .357 so I can finally get the .357 M&P snubby...
 
1 - 3 of 3 Posts
Top