MP-Pistol Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
343 Posts
Discussion Starter · #1 ·
I've been messing around with my seating die trying to get the exact setting I want but it never seems to get there. There always seems to be a variation of about +/- 0.002" from where I want it to be.

Basically, I tried to set up so that I got 1.128" ..... but with that setting I end up with rounds between 1.126"-1.130". I mean it's not bad considering I was just wondering if a vaiation like this is normal.



Dillion 550, .40, berrys plated, 1x fired brass
 

· Registered
Joined
·
343 Posts
Discussion Starter · #3 ·
That's what I though but wanted to be sure. I had at one point tried getting 1.130" but had plenty of rounds coming out at 1.134". So far to date my one and only FTF was with that setting, but that round measured out at 1.136" somehow.



So now I'm trying to stay at 1.130" max and tried setting it to 1.128" to account for the variation I was getting. At least I know it's not me :roll:
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top