MP-Pistol Forum banner

Roll Pins

2056 Views 4 Replies 4 Participants Last post by  Dan Burwell
What size punch should I use for the roll pins on the M&P? I don't want to mess these up. Is it OK to reuse the roll pins after they have been taken out?
1 - 1 of 5 Posts
I forgot about the post.

I'm not sure about the size of punch, I just used one that was the same size as the hole.

You can reuse the pins, but I try to smush them in when reinserting them. IE compress back into place.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.