MP-Pistol Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Has anyone swapped slides on a shield plus with another shield plus. For example I have shield plus performance center 3.1” with thumb safety and a shield plus with optic (new) also 3.1” barrel no thumb safety. Can I swap the slides? Has anyone shot this combo?
 

·
Registered
Joined
·
6 Posts
I have two shield plusses.
I tried to swap slides, just to check interchangeability. One slide fit the other frame, one didn't. I didn't try very hard. Wasn't willing to break anything by using force.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
I
I have two shield plusses.
I tried to swap slides, just to check interchangeability. One slide fit the other frame, one didn't. I didn't try very hard. Wasn't willing to break anything by using force.
can swap them with no issues just wondering if anyone has tried and fired them. I didn’t want to break anything but as far as I can tell they are identical and should work. Again these are 2 shield plus’s. Just one is performance center non-optic and the other is optic ready non performance center. Both are 3.1” barrels.
 

·
Registered
Joined
·
5 Posts
I

can swap them with no issues just wondering if anyone has tried and fired them. I didn’t want to break anything but as far as I can tell they are identical and should work. Again these are 2 shield plus’s. Just one is performance center non-optic and the other is optic ready non performance center. Both are 3.1” barrels.
They’ll function flawlessly. I have an OG shield 1.0 thumb safety, a 3.1” plus and 4” shield plus performance center. I run the original shield 1.0 slide on the shield plus frame (13 round frame plus sentimental reasons for the slide) also, I swap my 4” PC slide to the regular plus frame because that frame is cerakoted fde, and I think fde frames look good with black slides lol…both have ran perfect
 
1 - 4 of 4 Posts
Top