MP-Pistol Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #3 ·
It's the full size, I can get it to fit if I back out the set screws engage the rail then retighten them, tight is right!. The problem is that once I take it off I have to repeat the process!! I put it on a night then off during the day. Any suggestions?
 

·
Registered
Joined
·
190 Posts
I have never had to loosen and retignten any screws to get any of my X200s to fit my M&P. All you should have to do is apply a little extra force to the light to push it into position.
 

·
Registered
Joined
·
30 Posts
NCPatrolAR said:
I have never had to loosen and retignten any screws to get any of my X200s to fit my M&P. All you should have to do is apply a little extra force to the light to push it into position.


I use the Streamlight TLR-2 on my M&P 9MM. Clamp on and tigthen down and your set.

Have over 200 rounds through with no issues of becoming loose.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top