MP-Pistol Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter #1
Looking at every thing real close trying to figure our why I am getting a lot of primer flow.Not causing any problems flowing back in the firing pin channel.It does it with all different types of ammunition but varies in size.The extractor when it picks up the shell it goes all way to the start of where the slope of the case starts to slope to the rim.Big gap between the shell and the slide when it grabs the shell. Really surprised I am not having any problems but none with any type are brand of ammunition.I did find a few cases where the the case rim had slamed into the chamber rim and the case had marks from slide slaming into the shell.The chamber is to short to allow a case at the max sammi specks.The extractor should be holding the case to the slide but it just pushes it against the opposite side of the slide.The chamber is not to tight so that is not a problem.Surprised I don't have feeding problems with the shell not held tight and a lot of wiggle room because of the gap.



Ed
 
1 - 1 of 1 Posts
Top